Zuma 50 '02-'11

A copper head gasket dissipates heat much more efficiently than the stock aluminum head gasket

Replacement air box collar/sleeve. This goes inside the rubber bushing on the airbox and is commonly lost. 

Stock Replacement Horn 12V Easy Mount. This is a great alternative to buying an expensive OEM horn!

Changing tires? Replace the valve stems! Fits every supported model, Zuma 50 & 125, and YSR50

OEM Yamaha Part 3XY-E7623-00

A simple bungee net with hooks to hold down helmets, bags, or other gear to your rack or seat. Very handy, and stores  small! 13x13" unstretched20x...

Zuma 50 '12-'19 fork boot SOLD EACH! Be sure to add TWO to your cart if you'd like a pair. 

Case dowel pin for Zuma 50 1989-2011. This is the dowel for the two case halves, not the one for the transmission cover! 

Replacement Banjo Bolt Washer These should be replaced whenever you remove banjo bolt. These come in copper and aluminum. They serve the same funct...

Nut for end of shaft    

This is necessary to keep single cable carbs from being turned in wrong direction which causes unexpected acceleration and eventually frays the cab...

17mm Clutch Nut    

Open Ended Black Soft Foam Grips with Black End pieces Ready for Bar Ends Be sure to grab some Grip Glue to keep the grips secure!

Oil Seal Zuma 50 '08-'11

Turn Signal Lens '02-'11 (front, rear, left, right, all the same)

After being asked from numerous customers,  I decided to stock these gaskets. They are extremely strong, and won't blow out or fail if installed co...

The stock Yamaha circlips do not have an "ear" making it very difficult to install. These circlips have an ear and make the job easy!

The cost of petroleum has skyrocketed and as a result the cost of seals has to. Includes: Left Crank Seal Right Crank Seal Primary Drive Seal Stato...

It is important that you use a short reach extended tip NGK's Standard Plugs are Constructed for Longer Life and Optimum Performance Trivalent Met...

These are the standard Zuma Plugs. The 7 is the hottest and the 8 is the coldest. The 7 is standard from the factory. Most folks run an 8. It is im...

Round "doughnut" Exhaust gasket

38mm Clutch Nut that holds Clutch shoes to axle (41mm = 1 1/2") Same as the 41mm clutch nut but less expensive - no compromise in quality (it is a ...

Variator Sliders are the spacers between your variator pulley and the back plate. Regular service of these guides is often overlooked and may cause...